1.5" 90° Silicone Elbow 135° Bends 90 degree bend to build

90 degree bend to build or finish your intake

You’ll notice the PTFE line being opened up by the top part of the fitting

Pressure Rating: 1500 PSI – note: crimp-on fittings are recommended for applications over 500 PSI

Our turbos come with a 2 YEAR WARRANTY

You hold the power to make this system as mild or wild as you desire

1.5" 90° Silicone Elbow 135° Bends 90 degree bend to build135 degree bend to build or finish your intake. Applications: Joining your intake pipe to the throttle body assembly, air metering assembly, intercooler, BOV pipe, or turbo inlet outlet. Custom compressor, intercooler or inlet piping for turbo supercharged car Custom cold air intake for nonturbo car Replacement of all factory rubber parts These silicone parts can be used in trucks, recreational vehicles, boats, or anything else with an engine. Genuine